Home
Textile Testing Equipment
- Eyeglasses Test Equipment
- Plastic And Film Packaging Test Equipment
- Sample preparation
- Carton Package Testing Equipment
- Toys Testing Instrument
- Environmental Testing Equipment
- Footwear Testing Equipment
-
Textile Testing Equipment
- Zipper & Button & Velcro Tape Tester
- Protective Clothing & Mask Tester
- Gloves & Socks Tester
- Feather & Down Tester
- Nonwoven Textile Tester
- Geotextile Tester
- Flammability Test Equipment
- Yarn and FiberTesting
- Washing & Laundering
- Tensile Burst Tear Strength Tester
- Fabric And Garment Testing
- Dyeing and Finishing Tester
- Color Fastness Testing
- Abrasion and Pilling Tester
0102030405
Molten Metal Impact Tester for Welding Gloves and Welding Clothing H122
Overview
Produced in accordance with relevant standards , it is mainly used for testing the molten metal impact resistance of various fabrics and composite fabrics such as welding gloves and welding clothing that are used to prevent burns from molten metal splashes. It is widely used in special labor protection product supervision and inspection stations, production safety science research institutes, product quality inspection institutes, welding gloves, and welding clothing manufacturers.
Application
Fabric
Standards
GB / T38306-2019 , GB 8965.2-2022 , GB38453-2019 , GB17599 FZ/T 73040-2010
EN407, EN 348, ISO 9150, EN 348
Key Parameters
|
Model |
H122 |
|
Welding tip diameter |
1.2 mm ± 0. 1 mm . |
|
Metal speed |
0 - 15 g / min, adjustable, standard 10 ± 1 g / min |
|
Oxygen pressure |
0-1000Kpa, adjustable, standard 250Kpa (Gas self-prepared) |
|
Acetylene pressure |
0-200Kpa, adjustable, standard 50kpa (Gas self-prepared) |
|
Flame length |
0-20 mm , adjustable, standard 8mm |
|
Guide groove angle |
0-90 。, adjustable, standard 45 。 |
|
Sample size |
120 mm X20 mm |
|
Power supply |
220V 50HZ 1.5KW |
Product Details
Test stand
Control panel
Production Processes
Process design and design and manufacture of specialized process equipment
Machining of components
Assembly of products
Comprehensive testing of machines
Scenarios of Use
Laboratory
Textile factory
Operation
Connecting the air supply
Connect the air supply to the instrument.
Add distilled water
Connect tube from the freestanding funnel to the water connector located at the back right-hand corner of the SST unit. Add distilled water.
Put in filte
Unscrew the screws and remove the top plate,Take away the reflector.
Put in filter.
Install the xenon lamp
Install the xenon lamp and connect the lamp cabler.Replace the top cover and tighten the set screws.
Mount the sample
Mount the sample on the sample clamp.
BPT Sampling
Place the sample into the test chamber and close the door.Be careful to avoid covering the BPT sensor.
Transportation
Packing System
1. Products are covered with air bubble film before put them into composite board standard export wooden case. To ensure waterproof, moistureproof, corrosion, anti-corrosion and security.
2. Package with shipping mark in line with International and national standards, which is easy for handling, loading and unloading.
3. Packing materials selected accorded with economic and safety requirements
4. Compliance with environmental requirements.
For Metal Box Package
For Carton Package
For Wooden Case
