Home
Toys Testing Instrument
- Eyeglasses Test Equipment
- Plastic And Film Packaging Test Equipment
- Sample preparation
- Carton Package Testing Equipment
- Toys Testing Instrument
- Environmental Testing Equipment
- Footwear Testing Equipment
-
Textile Testing Equipment
- Zipper & Button & Velcro Tape Tester
- Protective Clothing & Mask Tester
- Gloves & Socks Tester
- Feather & Down Tester
- Nonwoven Textile Tester
- Geotextile Tester
- Flammability Test Equipment
- Yarn and FiberTesting
- Washing & Laundering
- Tensile Burst Tear Strength Tester
- Fabric And Garment Testing
- Dyeing and Finishing Tester
- Color Fastness Testing
- Abrasion and Pilling Tester
0102030405
Toys lab equipment ASTM Flexure Tester T044
Overview
This test shall be applied to each component of a toy containing metal wire(s), or other metal material(s), for stiffening or for retention of form if the component can be bent through a 60-degree arc by a maximum force of 15 pounds 0.5 pound (6.80 kilograms) applied perpendicularly to the major axis of the component at a point 2 inches 0.05 inch (5 centimeters) from the intersection of the component with the main body of the toy or at the end of the component if the component is less than 2 inches 0.05 inch (5 centimeters) long.
Application
Toys
Toys
Standards
ASTM F963 section 8.12, 16
16 CFR 1500 section 51 and 52 and 53
GB6675-2 section 5.24.8
Key Parameters
|
Model |
T044A |
|
Material |
Stainless steel |
|
Test angle |
120 degrees |
Product Details
Bend
Splint
Production Processes
Process design and design and manufacture of specialized process equipment
Machining of components
Assembly of products
Comprehensive testing of machines
Scenarios of Use
Laboratory
Textile factory
Operation
Connecting the air supply
Connect the air supply to the instrument.
Add distilled water
Connect tube from the freestanding funnel to the water connector located at the back right-hand corner of the SST unit. Add distilled water.
Put in filte
Unscrew the screws and remove the top plate,Take away the reflector.
Put in filter.
Install the xenon lamp
Install the xenon lamp and connect the lamp cabler.Replace the top cover and tighten the set screws.
Mount the sample
Mount the sample on the sample clamp.
BPT Sampling
Place the sample into the test chamber and close the door.Be careful to avoid covering the BPT sensor.
Transportation
Packing System
1. Products are covered with air bubble film before put them into composite board standard export wooden case. To ensure waterproof, moistureproof, corrosion, anti-corrosion and security.
2. Package with shipping mark in line with International and national standards, which is easy for handling, loading and unloading.
3. Packing materials selected accorded with economic and safety requirements
4. Compliance with environmental requirements.
For Metal Box Package
For Carton Package
For Wooden Case
